![]() ![]() Then remove the key from the ignition key cylinder. 4.Turn the ignition switch from LOCK to ON and back to LOCK at approximately 1 second intervals 1 to 5 times to select a mode (see below). This step must be done within 40 seconds of step 2.2. Then insert the key into the ignition key cylinder and close the driver door. 3.After the above operation, close and open the driver's door twice (End with door open). This step must be done within 40 seconds of step 2.1. Then insert the key into the ignition key cylinder and remove it. (End with key removed) 2.After the above operation, close and open the driver's door twice (End with door open). 2.Perform the following operations to select the desired mode: 1.Insert and remove the key from the ignition switch twice within 5 seconds. 1.To begin programming, first ensure the follow conditions have been met: 1.No key is inserted in the ignition key cylinder. Use this mode when a transmitter is lost. Prohibition mode: This mode is used to erase all programmed transmitters and cancel the wireless door lock function. Confirmation mode: This mode is for confirming how many existing transmitters are programmed before adding any transmitters. Rewrite mode: This mode is used to erase all of the previously programmed transmitters and should be used when installing a new receiver. If the number of programmed transmitters exceeds 4, the previously programmed transmitters will be correspondingly erased in order, starting from the transmitter programmed first. ![]() They are as follows: Add mode: This mode is used for adding new or additional transmitters. I will enter the procedure here:Programming Keyless Entry Transmitters Four programming modes are available in the remote control door lock receiver (RCDLR). I used a programming instruction from mitchell and it worked ok, it did take me a couple trys but I got it to work. ![]() I programmed a new key and remote to my 2010 Vibe. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |